-40%

F*CK IT EDITION silver and red emblem fits Chevy Honda Toyota Ford Car Truck 2x

$ 52.27

Availability: 98 in stock
  • Manufacturer Part Number: AMP-85100-387x2
  • Attachment Type: Adhesive
  • Type: Emblem
  • Color: silver and red
  • Condition: New
  • Country/Region of Manufacture: United States
  • Suitable For: Car
  • Primary Color: Silver with Red Lettering
  • Placement on Vehicle: Front, Fuel Tank, Hood, Left, Lower, Rear, Right, Roof, Side, Tailgate, Upper
  • UPC: 745396506261
  • Brand: rombutterfly
  • Interchange Part Number: 22786435, 22786809, 23463809, 84143537, 84149654
  • Manufacturer Warranty: 3 Months
  • Universal Fitment: Yes
  • Dimensions: 3 1/8 x 1 1/4 or 80mm x 30mm
  • Theme: Words & Phrases

    Description

    2x FCK IT EDITION silver emblem Badges fits Chevy Honda Toyota Ford Car Truck
    Specification:
    3D Dome Surface
    3 1/8 x 1 1/4 or 80mm x 30mm
    Red Letters on Black Background
    Automotive Adhesive for Long Lasting Installation
    We back our Quality with a 100% Satisfaction Guarantee!
    Package included:
    2pc Emblem Set
    Note:
    Usually ships the same business day
    Important
    Vehicle Emblem and Badge Installation Instructions
    Step 1
    Removing old emblem or emblems can done neatly by using a heat gun on the lowest setting. Carefully pry the old emblem off using a putty scraper.
    Step 2
    Then clean the area where the emblem adhesive still remains. Use adhesive cleaner and a clean rag.
    Step 3
    Most important step is to use rubbing alcohol on a different rag to clean the remaining grease or dirt from the location. Allow it to air dry.
    Step 4
    Using a level or ruler to create a straight line parallel to the ground, marking the location of the emblem against desired surface or body lines. Use painter’s tape to make your guide lines.
    Step 5
    Prepare the emblem, making sure it's clean. Be sure to never touch the application adhesive on the back of the emblem after Remove the backing tape from the adhesive.
    Step 6
    Hold the emblem just above the surface in the desired location, using the painter’s tape as a guide to keep the emblem level located properly.
    Step 7
    Stick the emblem on and hold it in place until the adhesive has had a chance to setup bond on the surface of the vehicle. This usually takes 10 seconds.